View VW6754_4288119.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

VW6754
Ultra small reflowable UXGA camera module
Data Brief
Features

2 megapixel resolution sensor (1600 x 1200) High quality lens Compact size: 5.0 mm x 5.0 mm x 3.8 mm Lead-free reflowable BGA packaging SMIA 1.0 profile 2 compatible Video data interface - CCP 2.0 maximum 640 MHz Command interface - CCI Analog power supply from 2.4 V to 2.9 V Digital power supply from 1.7 V to 2.9 V On-board 10-bit ADC Integral EMC shielding and EMI reduction techniques Ultra low power standby mode On-chip PLL Smooth frame rate control Defect correction 4 channel anti-vignette
Description
The VW6754 lead free Though Silicon Via BGA reflowable 2 megapixel camera module is designed for use across a range of mobile phone handsets and accessories. It is suitable for high quality still camera function and also supports video modes. The camera silicon device is SMIA 1.0 profile 2 compliant and is capable of streaming raw bayer 2 megapixel images at up to 30 fps. The VW6754 supports the CCI control and CCP 2.0 data interfaces. The camera is attached to the application motherboard using standard reflow process techniques. As different phone platforms have different baseband processors with varying capabilities, a software implementation of the required image processing algorithms on the phone baseband may not be possible. In such cases, a separate hardware accelerator (STV0986) or application engine (STn8815) device can be incorporated in the phone system to run the algorithms in hardware. The specifications of these devices are available in separate documents. The module design is optimized for both footprint and height. The multi-element lens provides excellent image quality at focus distances from 50 cm to infinity. The product is lead free. VW6754 offers ultra low power consumption in standby mode consuming less than 30 W.
February 2008
Rev 1
1/4
www.st.com
4
For further information contact your local STMicroelectronics sales office.
Overview
VW6754
1
Overview
Figure 1. Application diagram Figure 2. Block diagram
VW6754 2 Mpixel camera module
CLK PDN CCI CCP2.0
STV0984 or STV0986 Processor
CLK PDN I2C CCP2.0 or ITU
Baseband or Application Processor
VW6754
EXTCLK XSHUTDOWN PLL and Clock Management Power Mgmt CCI Receiver Sensor Control Registers Power-On Reset 2 Mpixel Pixel array 1152 x 864 VDIG DGND
Readout
CCI CCP2.0
SMIA Rx'er
CLKP CLKN DATAP DATAN
CCP2.0 Transmitter
VW6754 2 Mpixel camera module
CLK PDN
SCL SDA
Baseband or Application Processor
SMIA profile 0 frame formatter
Y Decoder
VANA AGND
Column ADC X Decoder Line SRAM
Table 1.
Technical specifications
Parameter Descriptions 1600 x 1200 (UXGA) ST IMG175 process 1.75 m x 1.75 m + 81 dB + 24 dB (max) 60 dB 37 dB (@ 100 lux) < 10 lux Analog: 2.4 V to 2.9 V
Pixel resolution Sensor technology Pixel size Exposure control Analog gain Dynamic range Signal to noise Minimum illumination(1) Supply voltage
Digital: 1.7 V to 2.9 V Average power consumption 30fps Package size (lxwxh) Lens TV distortion Module relative Package type System attach illumination(2) <200 mW 5.0 mm x 5.0 mm x 3.8 mm 51 +/- 2 HFOV Typical <|1.0%| Typical 50% +/-2% BGA Lead-free reflowable soldering process F/2.8
1. At minimum illumination the image is correctly exposed with D65 illumination on 18% grey card at 30fps 2. With anti-vignette function
2/4
VW6754
Ordering information
2
Ordering information
Table 2. Order code
Package BGA 5.0 mm x 5.0 mm x 3.8 mm Tape and reel Packing
Order code VW6754R0Y6/TR
3
Revision history
Table 3.
Date 07-Feb-2008
Document revision history
Revision 1 Initial release. Changes
3/4
VW6754
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries ("ST") reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST's terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST'S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER'S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
(c) 2008 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com
4/4

▲Up To Search▲

Price & Availability of VW6754

	To Download VW6754 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .